Ive seen videos online of folks doing it themselves with different software, and Im fairly tech savvy, but Id rather not take a chance on damaging my cluster. Is there a less expensive place to use for this? Is that a possible problem 5 years from now? Also this is the expensive option, and money is tight. I read of at least one person having an issue with this down the road. I know I can send the cluster to have it deleted, then tape over the light. This seems to be the route most folks go. I also read, quite some time back, and not on this forum, about just replacing the immo antenna/pick up coil, but cant seem to find that part available anywhere. Then I came across a video from the UK about a similar issue, and it was the solder joints on the CAN-BUS connector on the cluster. What Im trying to find out is, Ive read there is a solder connection somewhere that needs to be repaired most times, but the fellow that started that thread never updated it with a procedure or a location. Its been pretty cold here, and Ive got another vehicle, although it gets awful mileage, so Ive been trying to sort this out. Usually, the next time or two it would be fine. Id had intermittent issues over the last two years where it would start and immediately die, then the flashing immo light.
